PRI VOICE configuration with MGCP Protocol
PRI interface configuration
for a voice circuit with an assumption that the cable is located at slot #0 and
port #2
network-clock-participate wic
0
network-clock-select 1 T1
0/2/0 >>>> clock priority
controller T1 0/2/0
cablelength long 0db
pri-group timeslots 1-24 service mgcp
interface Serial0/2/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
isdn bind-l3 ccm-manager
no cdp enable
RTR01#sh network
Network Clock Configuration
---------------------------
Priority
Clock Source Clock State Clock Type
1
T1 0/2/0 GOOD T1 primary
10
Backplane GOOD PLL backup
T1 0/2/0 is up.
Applique type is Channelized T1
Cablelength is long 0db
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info FPGA Rev: 08121917, FPGA Type:
PRK4
Framing is ESF, Line Code is B8ZS, Clock
Source is Line.
No comments:
Post a Comment